Skip to content

New combi boilers, fitted from £3,300Combis fitted from £3,300 Get your price in 2 minutesGet your price

Covering every BS, BA, GL, SN, NP and CF postcode

Gas Safe registered, no. 987082 Request a callback Contact Track a job Emergency line 24/7 0117 463 7103

How to Repressurise Your Boiler

Boiler pressure below 1 bar? A step-by-step guide to topping it up with the filling loop, and what it means if it keeps dropping.

2 min read Updated 9 November 2026

Low pressure is one of the most common reasons a combi or system boiler stops working. Topping it up takes five minutes and needs no tools on most boilers.

Check the gauge

Look for the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold, it should read between 1 and 1.5 bar. Many gauges have a green zone. If it’s below 1, or in the red, it needs topping up.

Find the filling loop

The filling loop connects the cold mains to the heating system. It’s usually under the boiler and looks like:

  • A silver braided hose with a small valve at each end, or
  • A built-in lever or key underneath the boiler on some models (your manual will show where)

Top it up

  1. Turn the heating off and let the boiler cool.
  2. Make sure both ends of the hose are connected tightly.
  3. Open the first valve, then slowly open the second. You’ll hear water flowing.
  4. Watch the gauge. Close both valves when it reaches about 1.2 bar.
  5. Reset the boiler if it shows a fault, and turn the heating back on.

If you go over 1.5 bar, bleed a radiator to bring it down a little.

If it keeps dropping

Topping up once after bleeding radiators is normal. Needing to do it every week or two isn’t. Water is escaping somewhere: a small leak on a valve, a faulty pressure relief valve (check for drips from the copper pipe outside), or a failed expansion vessel inside the boiler. That needs an engineer.

This guide is general information. If you’re ever unsure, or anything involves gas, stop and call a Gas Safe registered engineer.

Questions people ask

What should my boiler pressure be?

Around 1 to 1.5 bar when cold. It rises a little when the heating is on, which is normal.

Can high pressure be dangerous?

Boilers have a relief valve that opens to release pressure safely. If the gauge regularly goes above about 2.5 bar, book an engineer.

Let’s get you sorted

Book online in a few minutes and we’ll confirm your appointment with you directly.

Call Book online