Every modern condensing boiler has a condensate pipe: a plastic pipe, usually white or grey, that carries waste water from the boiler to a drain. If it runs outside, it can freeze in a cold snap. The boiler then backs up and locks out, often with a gurgling noise and a flame or ignition fault code.
How to thaw it
- Find the pipe. Follow the plastic pipe from the bottom of the boiler to where it leaves the house. The frozen part is usually the end, or a bend outside.
- Pour warm water along it. Use a kettle of warm water, not boiling, which can crack the plastic. Pour it slowly along the outside section, starting at the end.
- Or use a hot water bottle or heat wrap on the pipe.
- Reset the boiler once the ice has cleared. It may take a few minutes to start.
Never use a blowtorch or direct flame.
Stop it happening again
- Lagging the outside section with waterproof pipe insulation
- Re-routing the pipe internally where possible
- Increasing the pipe size for the outside run
We can do any of these, often during a service or repair.
If it doesn’t work
If the boiler still won’t start after thawing, or you can’t reach the pipe safely, book an engineer.
This guide is general information. If you’re ever unsure, or anything involves gas, stop and call a Gas Safe registered engineer.