Skip to content

New combi boilers, fitted from £3,300Combis fitted from £3,300 Get your price in 2 minutesGet your price

Covering every BS, BA, GL, SN, NP and CF postcode

Gas Safe registered, no. 987082 Request a callback Contact Track a job Emergency line 24/7 0117 463 7103

Bright walk-in shower with a handheld shower head on a riser rail

Electric Showers

Shower gone cold, cutting out or leaking? We repair electric showers, swap them like for like or fit a more powerful one, with the price agreed before we start.

Gas Safe registered, no. 987082

Plumbing call-out, first hour

£78

Covers the visit and the first hour on site. Further labour and parts are quoted before we start.

Book online0117 463 7103

An electric shower heats cold mains water as it flows, so you get hot water whenever you want it, even when the boiler is off. When one goes wrong it’s usually one of a handful of parts, and most showers are repaired or replaced in a single visit.

Signs your shower needs looking at

  • The water runs cold, or swings between hot and cold
  • It cuts out part-way through, or won’t start at all
  • A weak or patchy spray, even after cleaning the head
  • Buttons or dials that don’t respond, or warning lights on the unit
  • Water dripping from the bottom of the unit
  • A pull-cord switch that buzzes, feels warm or has scorch marks

Smell burning or see scorch marks? Stop using the shower, switch it off at the pull-cord and at your fuse box, and book a repair. Don’t use it again until it’s been checked.

Repair or replace?

Many faults come down to a single part: the pressure relief device, the solenoid valve, the heating element or a flow switch. On a newer shower, a repair is usually the right call. On a shower more than about ten years old, or one where parts are hard to find, a new unit is often quicker and better value. We’ll tell you which makes sense, and what it costs, before we start.

Like-for-like replacement

We fit a new shower of the same or lower power on your existing circuit, after checking the cable, the isolating switch and the water supply are in good order. We use the existing pipework and cable entry wherever we can, so there’s less making good. Most swaps are done in one visit.

Upgrading to a more powerful shower

A higher-power shower may need a bigger cable, a new isolating switch or a new circuit from the consumer unit. We can do all of it, and the electrical work is certified and notified to Building Control under the Building Regulations, so you get the paperwork. We’ll check what you’ve got and give you a fixed price before we start.

Choosing the right power

The power rating, in kilowatts (kW), decides how much hot water the shower can deliver. The colder the water coming in, the harder the shower has to work, which is why most electric showers feel weaker in winter.

Shower powerWinter flow, roughlySummer flow, roughly
8.5 kW3.8 litres a minute4.9 litres a minute
9.5 kW4.3 litres a minute5.4 litres a minute
10.5 kW4.7 litres a minute6 litres a minute

Figures are for a 40°C shower, with mains water at about 8°C in winter and 15°C in summer. Your own flow depends on your supply. The rating is printed on the unit or in its manual. Send us a photo of it when you book and we’ll come prepared.

What happens on the day

  1. We check the supply. Before anything is touched, we isolate the shower and test the circuit, the switch and the water pressure.
  2. We repair or fit. We fix the fault or fit your new shower, keeping disruption to the bathroom to a minimum.
  3. We test it properly. Temperature, flow and every safety cut-out are checked, and we make sure there are no leaks.
  4. We hand it over. We show you how the controls work and how to look after it, and leave the bathroom clean.

Electric or mixer?

An electric shower doesn’t rely on your boiler, which makes it a good choice for an en suite or second bathroom, or as a back-up when the boiler is off. A mixer shower takes hot water from your boiler or cylinder and usually gives a stronger flow. If you’re weighing them up, see showers and bathrooms or ask us when you book.

Looking after your shower

  • Descale the shower head every few months. Limescale is the most common cause of weak flow in hard-water areas like Bath and much of Bristol.
  • If you see water dripping from the unit, switch it off and book a repair. Water and electrics don’t mix.
  • Switch off at the pull-cord after use, as most manufacturers recommend.
Plumbing call-out, first hourCovers the visit and the first hour on site. Further labour and parts are quoted before we start.£78
Plumbing labourAfter the first hour. Charged in 30-minute blocks.£54 per hour

All prices include VAT at 20%.

Prefer to talk it through first? Request a callback and we’ll ring you.

Our four house rules, on every job

The price before the work
Our prices are on this site, and every repair is priced and agreed with you before we start.
A properly qualified engineer
Gas work is only ever done by a Gas Safe registered engineer. Ours is carried out by TempZilla (Gas Safe no. 987082).
Honest timings
For urgent jobs (no heating, no hot water or a leak you can’t stop) we aim to attend the same or next working day. If that changes, we tell you.
Straight advice
If a repair makes more sense than a new boiler, or you don’t need a powerflush, we’ll say so.

Questions about electric showers

How much does an electric shower repair cost?

Our plumbing call-out is £78, which covers the visit and the first hour on site. After that, labour is £54 per hour. We tell you the price of any parts or a new shower before we fit anything.

Why does my electric shower keep cutting out?

Usually the safety cut-out is doing its job because the water is overheating. That's often down to low flow: a scaled-up head, a kinked hose, low mains pressure or a failing part. Descale the head first. If it still cuts out, book a repair.

Why is my shower only lukewarm in winter?

Mains water is much colder in winter, so the same shower has to work harder. Turning the flow down a little helps. If it's still not warm enough, a more powerful shower may be the answer, and we can check whether your circuit can take one.

Can you fit a more powerful shower?

Yes. If your existing cable and circuit can't take it, we upgrade them too and give you the electrical certificate. We'll give you a fixed price first.

Should I repair or replace my shower?

If it's fairly new and the fault is a single part, a repair is usually best. On an older shower, a new unit is often better value. We'll give you the options and prices.

Can you supply the shower, or fit one I've bought?

Either. We can supply a shower to suit your circuit and your bathroom, or fit one you've bought. If you're buying your own, check the power rating with us first so it matches your circuit.

Let’s get you sorted

Book online in a few minutes and we’ll confirm your appointment with you directly.

Call Book online