A dripping tap wastes water and, if it’s the hot tap, energy too. The fix depends on the type of tap.
Which tap do you have?
- Traditional pillar or cross-head taps that take several turns to close usually have a rubber washer. A worn washer is the classic cause of drips.
- Quarter-turn taps that go from off to full in a quarter turn have ceramic discs. Drips mean a worn cartridge.
- Single-lever mixers have a cartridge inside that controls flow and temperature.
Before you start
Turn off the water to the tap, using the small isolation valve on the pipe under the sink (turn the slot across the pipe) or the stopcock. Open the tap to drain it and put the plug in so small parts can’t go down the drain.
Replacing a washer or cartridge
Remove the handle (often a hidden screw under a cap), unscrew the headgear or cartridge with a spanner, and take it to a plumbers’ merchant to match. Fit the new part and reassemble.
When to call us
Mixer cartridges are often specific to the brand, and older taps can be seized or corroded. If the tap body is damaged, it’s usually better value to replace the tap. We carry common washers and cartridges on the van.
This guide is general information. If you’re ever unsure, or anything involves gas, stop and call a Gas Safe registered engineer.